Search results
Results from the WOW.Com Content Network
It may be used to power a remote control receiver so that when infrared or radio-frequency signals are sent by a remote control device, the equipment can respond, typically by changing from standby to fully on mode. Standby power may be used to power a display, operate a clock, etc., without switching the equipment to full power.
An AC adapter or AC/DC adapter (also called a wall charger, power adapter, power brick, or wall wart) [1] is a type of external power supply, often enclosed in a case similar to an AC plug. [2] AC adapters deliver electric power to devices that lack internal components to draw voltage and power from mains power themselves.
Plug and socket connectors are usually made up of a male plug (typically pin contacts) and a female socket (typically receptacle contacts). Often, but not always, sockets are permanently fixed to a device as in a chassis connector (see above) , and plugs are attached to a cable.
Some devices, however, use a proper 4-pin Mini-DIN connector for power instead, presenting the possibility of mating such a connector with the wrong port (such as an S-Video output). Known as Kycon 3-pin and 4-pin DC power plugs. Erroneously also known as "Power DIN", [4] although different from any standardized Mini-DIN or DIN connector type.
Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using. If you don't have another browser, download a supported one for free. 2. Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything ...
A receptacle tester being used to check for some types of improper wiring of an outlet. For this particular tester, proper wiring is indicated by the two yellow lights. The outlet tester checks that each contact in the outlet appears to be connected to the correct wire in the building's electrical wiring. It can identify several common wiring ...
The device can be integral with the power plug, or a separate module within 12 inches of the plug. The protection device is equipped with "Test" and "Reset" buttons on the housing. An LCDI cord has a fine wire mesh around the conductors, and circuitry to detect current leaking from the conductors to the mesh, which would happen if the cord were ...
The adapter typically supplies power to the device through a thin electrical cord which terminates in a coaxial power connector often referred to as a "barrel plug" (so-named because of its cylindrical shape). The polarity of the adapter cord and plug must match the polarity of the device, meaning that the positive contact of the plug must mate ...