Search results
Results from the WOW.Com Content Network
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
There are varieties in how the SGPIO bus is implemented between vendors of HBAs and storage controllers - some vendors will send a continuous stream of data which is advantageous to quickly update the LEDs on a backplane after cables are removed and re-inserted, while others send data only when there is a need to update the LED pattern.
A typical EEPROM serial protocol consists of three phases: OP-code phase, address phase and data phase. The OP-code is usually the first 8 bits input to the serial input pin of the EEPROM device (or with most I²C devices, is implicit); followed by 8 to 24 bits of addressing, depending on the depth of the device, then the read or write data.
SCPI commands to an instrument may either perform a set operation (e.g. switching a power supply on) or a query operation (e.g. reading a voltage). Queries are issued to an instrument by appending a question-mark to the end of a command. Some commands can be used for both setting and querying an instrument.
Since the control signals for a serial port can be driven by any digital signal, some applications used the control lines of a serial port to monitor external devices, without exchanging serial data. A common commercial application of this principle was for some models of uninterruptible power supply which used the control lines to signal loss ...
The change prevents the chip from being recognised by drivers of any OS, effectively making them inoperable unless the product ID is changed back. [14] The behaviour was supported by a notice in the drivers' end user license agreement, which warned that use of the drivers with non-genuine FTDI products would "irretrievably damage" them. [14]
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module. Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
A partitioned data set (PDS) [7] is a data set containing multiple members, each of which holds a separate sub-data set, similar to a directory in other types of file systems. This type of data set is often used to hold load modules (old format bound executable programs), source program libraries (especially Assembler macro definitions), ISPF ...