Search results
Results from the WOW.Com Content Network
These are known as "SFE" fuses, as they were designed by the Society of Fuse Engineers to prevent the insertion of a grossly inadequate or unsafe fuse into the vehicle's fuse panel. [10] [11] These SFE fuses all have a 1 ⁄ 4 inch diameter, and the length varies according to the rating of the fuse.
Note: these fuses were manually traced from the following pdf-datasheets: (No part of the original PDF remains in this SVG file) Littlefuse.com: datasheet of Micro2 fuse; Littlefuse.com: datasheet of Micro3 fuse actually used version, with vector graphic of fuse) Littelfuse.com: datasheet of low-profile mini fuse
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
"Voltage rating of the fuse must be greater than or equal to what would become the open circuit voltage. For example, a glass tube fuse rated at 32 volts would not reliably interrupt current from a voltage source of 120 or 230 V. If a 32 V fuse attempts to interrupt the 120 or 230 V source, an arc may result.
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
A time-delay fuse (also known as an anti-surge or slow-blow fuse) is designed to allow a current which is above the rated value of the fuse to flow for a short period of time without the fuse blowing. These types of fuse are used on equipment such as motors, which can draw larger than normal currents for up to several seconds while coming up to ...
It’s better not to use annotation to give a diagram a title. Put the diagram inside a table and use the table caption to do it. That way it can easily be changed. Do not be tempted to use the WordArt button next to the text button. WordArt is the feature most responsible for those terrible looking amateur posters, and ads that can be seen in ...