Ad
related to: hypertherm 45 plasma cutter troubleshooting
Search results
Results from the WOW.Com Content Network
Plasma cutting. Plasma cutting is a process that cuts through electrically conductive materials by means of an accelerated jet of hot plasma. Typical materials cut with a plasma torch include steel, stainless steel, aluminum, brass and copper, although other conductive metals may be cut as well. Plasma cutting is often used in fabrication shops ...
Plasma torch. A plasma torch cutter. A plasma torch (also known as a plasma arc, plasma gun, plasma cutter, or plasmatron) is a device for generating a directed flow of plasma. [1][2][3] The plasma jet can be used for applications including plasma cutting, plasma arc welding, plasma spraying, and plasma gasification for waste disposal. [4]
To give an idea of the flow rate while plasma cutting: The flow of a Hypertherm plasma 260A for mild steel uses 42 l/min for the plasma gas (O2) and 104 l/min for the shield gas (air). The hole in the nozzle is about 2mm². Source: Hypertherm HPR260 manual. Devaes 08:36, 14 January 2008 (UTC) Reply
A plasma railgun is a linear accelerator which, like a projectile railgun, uses two long parallel electrodes to accelerate a "sliding short" armature. However, in a plasma railgun, the armature and ejected projectile consists of plasma, or hot, ionized, gas-like particles, instead of a solid slug of material.
Plasma arc welding (PAW) is an arc welding process similar to gas tungsten arc welding (GTAW). The electric arc is formed between an electrode (which is usually but not always made of sintered tungsten) and the workpiece. The key difference from GTAW is that in PAW, the electrode is positioned within the body of the torch, so the plasma arc is ...
Plasma cleaning is the removal of impurities and contaminants from surfaces through the use of an energetic plasma or dielectric barrier discharge (DBD) plasma created from gaseous species. Gases such as argon and oxygen, as well as mixtures such as air and hydrogen/nitrogen are used. The plasma is created by using high frequency voltages ...
Thermal spraying. Thermal spraying techniques are coating processes in which melted (or heated) materials are sprayed onto a surface. The "feedstock" (coating precursor) is heated by electrical (plasma or arc) or chemical means (combustion flame). Thermal spraying can provide thick coatings (approx. thickness range is 20 microns to several mm ...
A third process, full silicidation (FUSI) [157] was not pursued due to manufacturing problems. [158] Gate-first became dominant at the 22nm/20nm node. [159] [160] HKMG has been extended from planar transistors for use in FinFET and nanosheet transistors. [161] Hafnium silicon oxynitride can also be used instead of Hafnium oxide. [162] [163] [3 ...
Ad
related to: hypertherm 45 plasma cutter troubleshooting