enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tread plate - Wikipedia

   en.wikipedia.org/wiki/Tread_plate

   Tread plate. Tread plate, also known as checker plate and diamond plate, is a type of metal stock with a regular pattern or lines on one side for slip resistance. The most common alloy used for aluminium tread plate is 6061, although 5086-H34 and 3003-H231 are also used. [1] Diamond plate is usually steel, stainless steel or aluminium.

3. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   Sheet metal is metal formed into thin, flat pieces, usually by an industrial process. Thicknesses can vary significantly; extremely thin sheets are considered foil or leaf, and pieces thicker than 6 mm (0.25 in) are considered plate, such as plate steel, a class of structural steel. Sheet metal is available in flat pieces or coiled strips.

4. Material properties of diamond - Wikipedia

   en.wikipedia.org/wiki/Material_properties_of_diamond

   Material properties of diamond. Burns above 700 °C in air. Diamond is the allotrope of carbon in which the carbon atoms are arranged in the specific type of cubic lattice called diamond cubic. It is a crystal that is transparent to opaque and which is generally isotropic (no or very weak birefringence).

5. Corrugated galvanised iron - Wikipedia

   en.wikipedia.org/wiki/Corrugated_galvanised_iron

   Corrugated galvanised iron (CGI) or steel, colloquially corrugated iron (near universal), wriggly tin (taken from UK military slang), pailing (in Caribbean English), corrugated sheet metal (in North America), zinc (in Cyprus and Nigeria) or custom orb / corro sheet (Australia), is a building material composed of sheets of hot-dip galvanised ...

6. Cold-formed steel - Wikipedia

   en.wikipedia.org/wiki/Cold-formed_steel

   Cold-formed steel. Cold-formed steel (CFS) is the common term for steel products shaped by cold-working processes carried out near room temperature, such as rolling, pressing, stamping, bending, etc. Stock bars and sheets of cold-rolled steel (CRS) are commonly used in all areas of manufacturing. The terms are opposed to hot-formed steel and ...

7. Marston Mat - Wikipedia

   en.wikipedia.org/wiki/Marston_mat

   Sometimes the sheets were welded together. A typical later PSP was the M8 landing mat. A single piece weighed about 66 pounds (30 kg) and was 10 ft (3.0 m) long by 15 in (0.38 m) wide. The hole pattern for the sheet was produced to allow easier transportation by aircraft, since it weighed about two-thirds as much.