Ad
related to: simple current monitor opampautomationdirect.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Figure 3: Gain-boosted current mirror with op-amp feedback to increase output resistance MOSFET version of gain-boosted current mirror; M 1 and M 2 are in active mode, while M 3 and M 4 are in ohmic mode and act like resistors. The operational amplifier provides feedback that maintains a high output resistance.
An operational amplifier (often op amp or opamp) is a DC-coupled electronic voltage amplifier with a differential input, a (usually) single-ended output, [1] and an extremely high gain. Its name comes from its original use of performing mathematical operations in analog computers .
Figure 7: Typical op-amp current source. The simple transistor current source from Figure 4 can be improved by inserting the base-emitter junction of the transistor in the feedback loop of an op-amp (Figure 7). Now the op-amp increases its output voltage to compensate for the V BE drop. The circuit is actually a buffered non-inverting amplifier ...
Representative schematic of a current-feedback op-amp or amplifier. The current-feedback operational amplifier (CFOA or CFA) is a type of electronic amplifier whose inverting input is sensitive to current, rather than to voltage as in a conventional voltage-feedback operational amplifier (VFA).
Current mirrors are frequently used in the signal path of an integrated circuit, for example, for differential to single-ended signal conversion within an operational amplifier. At low bias currents, the impedances in the circuit are high enough that the effect of frequency may be dominated by device and parasitic capacitances shunting the ...
Many commercial op-amp offerings provide a method for tuning the operational amplifier to balance the inputs (e.g., "offset null" or "balance" pins that can interact with an external voltage source attached to a potentiometer). Alternatively, a tunable external voltage can be added to one of the inputs in order to balance out the offset effect.
Like a standard operational amplifier, the OTA also has a high impedance differential input stage and may be used with negative feedback. [3] But the OTA differs in that: The OTA outputs a current while a standard operational amplifier outputs a voltage. The OTA is usually used "open-loop"; without negative feedback in linear applications.
Basic fixed-threshold comparator and its derivatives - simple time delay relay and cascaded window monitor. To ensure fast turn-off transients, load resistor RL should provide on-state current of at least 5 mA [39] The simplest TL431-based comparator circuit requires a single external resistor to limit I CA at around 5 mA. [39]
Ad
related to: simple current monitor opampautomationdirect.com has been visited by 10K+ users in the past month