Search results
Results from the WOW.Com Content Network
The hands value has at most one digit after the decimal mark, and has an optional fraction. A precision of 2 assumes |frac=2 (round to nearest 1 ⁄ 2 inch). A precision of 3 or more assumes |frac=4 (round to nearest 1 ⁄ 4 inch).
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
The millimetre (SI symbol: mm) is a unit of length in the metric system equal to 10 −3 metres ( 1 / 1 000 m = 0.001 m). To help compare different orders of magnitude , this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm).
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
The typical range lies between 1 ⁄ 2 to 2 ⁄ 3 inch (12.7 to 16.9 mm) for the UK/US size system and 4 ⁄ 3 to 5 ⁄ 3 cm (13.3 to 16.7 mm) for the European size system, but may extend to 1 ⁄ 4 to 3 ⁄ 4 inch (6.4 to 19.1 mm) and 2 ⁄ 3 to 6 ⁄ 3 cm (6.7 to 20.0 mm).
medium-bore refers to calibers with a diameter of 0.33 inches (8.4 mm) to 0.39 inches (9.9 mm) large-bore refers to calibers with a diameter of 0.40 inches (10 mm) or larger There is much variance in the use of the term "small-bore", which over the years has changed considerably, with anything under 0.577 inches (14.7 mm) considered "small-bore ...
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [27] [33] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry. [27]
2 − 4 + 3 ⁄ 4 ≈ 0.0372 6 ... 12 inches (300 mm) was considered an untrimmed variant of the A4 height of 297 mm. ... and are indicated by a vulgar fraction ...