enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   For example, a four-layer PCB can be fabricated by starting from a two-sided copper-clad laminate, etch the circuitry on both sides, then laminate to the top and bottom pre-preg and copper foil. It is then drilled, plated, and etched again to get traces on top and bottom layers.

3. Routing (electronic design automation) - Wikipedia

   en.wikipedia.org/wiki/Routing_(electronic_design...

   For example, the allowed width and spacing on the lower layers may be four or more times smaller than the allowed widths and spacings on the upper layers. This introduces many additional complications not faced by routers for other applications such as printed circuit board or multi-chip module design.

4. List of electronic component packaging types - Wikipedia

   en.wikipedia.org/wiki/List_of_electronic...

   Through-hole technology uses holes drilled through the printed circuit board (PCB) for mounting the components. The component has leads that are soldered to pads on the PCB to electrically and mechanically connect them to the PCB. Three 14-pin (DIP14) plastic dual in-line packages containing IC chips.

5. Silicon controlled rectifier - Wikipedia

   en.wikipedia.org/wiki/Silicon_controlled_rectifier

   The principle of four-layer p–n–p–n switching was developed by Moll, Tanenbaum, Goldey, and Holonyak of Bell Laboratories in 1956. [1] The practical demonstration of silicon controlled switching and detailed theoretical behavior of a device in agreement with the experimental results was presented by Dr Ian M. Mackintosh of Bell ...

6. Via (electronics) - Wikipedia

   en.wikipedia.org/wiki/Via_(electronics)

   The gray and green layers are nonconducting, while the thin orange layers and red vias are conductive. A via (Latin, 'path' or 'way') is an electrical connection between two or more metal layers of a printed circuit boards (PCB) or integrated circuit. Essentially a via is a small drilled hole that goes through two or more adjacent layers; the ...

7. Gerber format - Wikipedia

   en.wikipedia.org/wiki/Gerber_format

   The Gerber format is an open, ASCII, vector format for printed circuit board (PCB) designs. [1] It is the de facto standard used by PCB industry software to describe the printed circuit board images: copper layers, solder mask, legend, drill data, etc. [2] [3] [4] The standard file extension is .GBR or .gbr [1] though other extensions like .GB, .geb or .gerber are also used.