Search results
Results from the WOW.Com Content Network
Water splitting is the chemical reaction in which water is broken down into oxygen and hydrogen: [1] 2 H 2 O → 2 H 2 + O 2 Efficient and economical water splitting would be a technological breakthrough that could underpin a hydrogen economy .
In pure water at the negatively charged cathode, a reduction reaction takes place, with electrons (e −) from the cathode being given to hydrogen cations to form hydrogen gas. At the positively charged anode, an oxidation reaction occurs, generating oxygen gas and giving electrons to the anode to complete the circuit.
The light-harvesting system of PSI uses multiple copies of the same transmembrane proteins used by PSII. The energy of absorbed light (in the form of delocalized, high-energy electrons) is funneled into the reaction center, where it excites special chlorophyll molecules (P700, with maximum light absorption at 700 nm) to a higher energy level.
The point of water electrolysis is to store energy in the form of hydrogen gas, a clean-burning fuel. The "oxygen evolution reaction (OER) is the major bottleneck [to water electrolysis] due to the sluggish kinetics of this four-electron transfer reaction." [6] All practical catalysts are heterogeneous. Diagram showing the overall chemical ...
The electrons from the initial light reaction reach Photosystem I, then are raised to a higher energy level by light energy and then received by an electron acceptor and reduce NADP + to NADPH. The electrons lost from Photosystem II get replaced by the oxidation of water, which is "split" into protons and oxygen by the oxygen-evolving complex ...
Photocatalysts must conform to several key principles in order to be considered effective at water splitting. A key principle is that H 2 and O 2 evolution should occur in a stoichiometric 2:1 ratio; significant deviation could be due to a flaw in the experimental setup and/or a side reaction, neither of which indicate a reliable photocatalyst for water splitting.
Figure 6:Reaction Coordinate Diagrams showing reactions with 0, 1 and 2 intermediates: The double-headed arrow shows the first, second and third step in each reaction coordinate diagram. In all three of these reactions the first step is the slow step because the activation energy from the reactants to the transition state is the highest.
2), a MO diagram may show one of the identical bonds to the central atom. For other polyatomic molecules, an MO diagram may show one or more bonds of interest in the molecules, leaving others out for simplicity. Often even for simple molecules, AO and MO levels of inner orbitals and their electrons may be omitted from a diagram for simplicity.