Search results
Results from the WOW.Com Content Network
The printer has an exceptionally small build volume of just 120x120x115mm, allowing it to be moved from place to place in the special backpack provided. The Ultimaker 2 Go's smaller size does come at a cost, however as the build plate is not heated and it is thus highly recommended to apply masking tape to the build plate before printing. [26]
Save a physical copy of important emails you've sent or received. Check out how to print emails and attachments in AOL Mail. 1. Open the email you'd like to print. 2. Click the Print icon. - A window will appear with your message. 2. Click the Print icon again. 3. Follow the browser prompts to finish printing.
Ultimaker Cura is used by over one million users worldwide and handles 1.4 million print jobs per week. It is the preferred 3D printing software for Ultimaker 3D printers, but it can be used with other printers as well. [6] [5] [7]
In September 2012, MakerBot introduced the Replicator 2. This newest model again increased the build volume, this time to 28.5 cm × 15.3 cm × 15.5 cm (11.2 in × 6.0 in × 6.1 in, L×W×H) and can print at 100 μm per layer. The dual extruder was changed back to a single extruder head, while the upgraded electronics, LCD, and gamepad remained ...
This is how the printer's key may appear in the first print run of a book. In this common example numbers are removed with subsequent printings, so if "1" is seen then the book is the first printing of that edition. If it is the second printing then the "1" is removed, meaning that the lowest number seen will be "2". [3]
A slicer is a toolpath generation software used in 3D printing. It facilitates the conversion of a 3D object model to specific instructions for the printer. The slicer converts a model in STL (stereolithography) format into printer commands in G-code format. This is particularly usable in fused filament fabrication and other related 3D printing ...
Canon's instructions (by phone) are to 'remove the batteries, rotate the on button and hold for 5 seconds, and then replace the battery'. The few lucky pictures are clear and in focus. A better solution (not provided by Canon) is to connect the camera to the TV or a computer. This may completely solve the problem.
Volume and Control Model, in sociology Topics referred to by the same term This disambiguation page lists articles associated with the title Volume control .