Search results
Results from the WOW.Com Content Network
This was Chevrolet's second 4.3L power plant; four other Chevrolet engines displaced 4.3L: the Vortec 4300 (a V6 based on the Chevrolet 350 cu in (5.7 L), with two cylinders removed), the original 265 cu in (4.3 L) V8 in 1954, a bored version of the stovebolt-era 235 inline six displacing 261 cu in (4.3 L), and a derivative of the Generation II ...
The bleed flow, 20% at Mach 3, was returned to the engine via 6 external tubes to cool the afterburner liner and primary nozzle as well as to provide extra air for combustion. [30] The J58 engine was the only operational turbojet engine, being designed to operate continuously even at maximum afterburning, for Mach 3.2 cruise.
Ram-air intake on a Kawasaki ZX-12R. A ram-air intake is any intake design which uses the dynamic air pressure created by vehicle motion, or ram pressure, to increase the static air pressure inside of the intake manifold on an internal combustion engine, thus allowing a greater massflow through the engine and hence increasing engine power.
2006 LL8 (Vortec 4200) engine in 2006 Chevrolet TrailBlazer. The LL8 (or Vortec 4200), is a straight-6 gasoline engine produced from 2002 to 2009. It was the first Atlas engine, and was introduced in 2002 for the Chevrolet TrailBlazer, GMC Envoy, and Oldsmobile Bravada. The engine was also used in the Buick Rainier, Saab 9-7X, and Isuzu Ascender.
The 90° V6 engine uses the same transmission bellhousing pattern as the Chevrolet small-block V8 engine. The oil pan dipstick is located on the passenger side above the oil pan rail; this design was phased in on both the 90° V6 and Small Block Chevrolet assembly lines (for engines manufactured after 1979) sharing the same casting dies. All ...
Concorde's Air Intake Control System also pioneered the use of digital data highways (multiplexed serial data buses) which connected the Air Intake Sensor Units that collected aerodynamic data at the nose of the aircraft (total pressure, static pressure, angle of attack and sideslip) and sent it to the Air Intake Control Units located nearer ...
The #1 cylinder is at the right rear with cylinders 1, 3, and 5 on the right, while #2 is the left rear with cylinders 2, 4, and 6 on the left. [2]: 24 The firing order is: 1-4-5-2-3-6. The crankcase is cast as two box-section halves. The assembled crankcase provides for four main bearings. There are four cylinder head studs per cylinder, for a ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.