enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...

3. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

4. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   A collet / ˈ k ɒ l ɪ t / is a segmented sleeve, band or collar. [1] [2] One of the two radial surfaces of a collet is usually tapered (i.e a truncated cone) and the other is cylindrical. The term collet commonly refers to a type of chuck that uses collets to hold either a workpiece or a tool (such as a drill), but collets have other ...

5. Bottom hole assembly - Wikipedia

   en.wikipedia.org/wiki/Bottom_hole_assembly

   Rotary assemblies [2] are commonly used where formations are predictable and the rig economics are an issue. In such an assembly the weight of the drill collars gives the BHA the tendency to sag or flex to the low side of the hole, collar stiffness length and stabiliser diameter and placement are engineered as a means of controlling the flex of the BHA.

6. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Machine tool operators must be able to install or remove tool bits quickly and easily. A lathe, for example, has a rotating spindle in its headstock, to which one may want to mount a spur drive or work in a collet. Another example is a drill press, to which an operator may want to mount a bit directly, or using a drill chuck.

7. List of components of oil drilling rigs - Wikipedia

   en.wikipedia.org/wiki/List_of_components_of_oil...

   Drill bit (#26) is a device attached to the end of the drill string that breaks apart the rock being drilled. It contains jets through which the drilling fluid exits. Drill floor (#21) is the area on the rig where the tools are located to make the connections of the drill pipe, bottom hole assembly, tools and bit. It is considered the main area ...