Search results
Results from the WOW.Com Content Network
The Spanning Tree Protocol (STP) is a network protocol that builds a loop-free logical topology for Ethernet networks.The basic function of STP is to prevent bridge loops and the broadcast radiation that results from them.
Data Center Bridging Capabilities Exchange Protocol (DCBX): a discovery and capability exchange protocol that is used for conveying capabilities and configuration of the above features between neighbors to ensure consistent configuration across the network. This protocol leverages functionality provided by IEEE 802.1AB . It is actually included ...
Technical Report 069 (TR-069) is a document by the Broadband Forum that specifies the CPE WAN Management Protocol (CWMP). CWMP is a SOAP -based protocol for communication between an internet service provider auto configuration server (ACS) and customer-premises equipment (CPE).
In contrast to standard Ethernet according to IEEE 802.3 and Ethernet bridging according to IEEE 802.1Q, time is very important in TSN networks.For real-time communication with hard, non-negotiable time boundaries for end-to-end transmission latencies, all devices in this network need to have a common time reference and therefore, need to synchronize their clocks among each other.
UPnP logo as promoted by the UPnP Forum (2001–2016) and Open Connectivity Foundation (2016–present). Universal Plug and Play (UPnP) is a set of networking protocols on the Internet Protocol (IP) that permits networked devices, such as personal computers, printers, Internet gateways, Wi-Fi access points and mobile devices, to seamlessly discover each other's presence on the network and ...
TAP can be used to create a user space network bridge. [2] Packets sent by an operating system via a TUN/TAP device are delivered to a user space program which attaches itself to the device. A user space program may also pass packets into a TUN/TAP device.
Simple Network Management Protocol (SNMP) is an Internet Standard protocol for collecting and organizing information about managed devices on IP networks and for modifying that information to change device behavior.
debugWIRE is activated by setting (programming to zero) of the fuse DWEN (debugWIRE enable), normally located in the high fuse byte. After this action the /RESET pin function isn't available anymore and the ISP protocol cannot be used. debugWIRE can be disabled with any of the mentioned debuggers by sending a special reset command that disables temporarily the debugWIRE function and reenables ...