Search results
Results from the WOW.Com Content Network
Structural steel welding - Welding of steel structures subject to high levels of fatigue loading AS/NZS 1554.6: Structural steel welding - Welding stainless steels for structural purposes AS/NZS 1554.7: Structural steel welding - Welding of sheet steel structures AS/NZS 3992: Pressure equipment - Welding and brazing qualification AS/NZS 4855
The Canadian Welding Bureau, through CSA Standards W47.1, [3] W47.2 [4] and W186, [5] specifies both a WPS and a Welding Procedure Data Sheet (WPDS) to provide direction to the welding supervisor, welders and welding operators. The WPS provides general information on the welding process and material grouping being welded, while the WPDS ...
The progression of thicknesses is clear in column 3 (U.S. standard for sheet and plate iron and steel 64ths inch (delta)). The thicknesses vary first by 1 ⁄ 32 inch in higher thicknesses and then step down to increments of 1 ⁄ 64 inch, then 1 ⁄ 128 inch, with the final increments at decimal fractions of 1 ⁄ 64 inch.
Self-drilling screws with tapping screw thread – Dimensions, requirements and testing: Withdrawn: ISO 10666, ISO 15480, ISO 15481, ISO 15482, ISO 15483: DIN 7513: Hexagon head and slotted head thread cutting screws – Dimensions, requirements and testing: Active: DIN 7516: Cross recessed head thread cutting screws – Dimensions ...
Gusset plates can be made into a variety of shapes and sizes and from a range of materials. Gusset plates are usually square or rectangular, but can be triangular or made into a customized shape to fit the joint. The shape of each plate is designed so that welding or bolts can be applied to different edges of the plate. [2]
In the era of commercial wrought iron, blooms were slag-riddled iron castings poured in a bloomery before being worked into wrought iron. In the era of commercial steel, blooms are intermediate-stage pieces of steel produced by a first pass of rolling (in a blooming mill) that works the ingots down to a smaller cross-sectional area, but still greater than 36 in 2 (230 cm 2). [1]
The face of the weld is the outer visual or hypotenuse that you see when looking at a fillet weld. The legs are the other two sides of the triangular fillet weld. The leg length is usually designated as the size of the weld. The throat of the weld is the distance from the center of the face to the root of the weld.
Iron, different steels, and even cast-iron can be welded to each other, provided that their carbon content is close enough that the welding ranges overlap. Pure iron can be welded when nearly white hot; between 2,500 °F (1,400 °C) and 2,700 °F (1,500 °C). Steel with a carbon content of 2.0% can be welded when orangish-yellow, between 1,700 ...