Search results
Results from the WOW.Com Content Network
Use of this expression allows the effect of a species not involved in the redox reaction, such as the hydrogen ion in a half-reaction such as MnO − 4 + 8 H + + 5 e − ⇌ Mn 2+ + 4 H 2 O. to be taken into account. The equilibrium constant for a full redox reaction can be obtained from the standard redox potentials of the constituent half ...
In a chemical reaction, chemical equilibrium is the state in which both the reactants and products are present in concentrations which have no further tendency to change with time, so that there is no observable change in the properties of the system. [1] This state results when the forward reaction proceeds at the same rate as the reverse ...
In thermodynamics, an activity coefficient is a factor used to account for deviation of a mixture of chemical substances from ideal behaviour. [1] In an ideal mixture, the microscopic interactions between each pair of chemical species are the same (or macroscopically equivalent, the enthalpy change of solution and volume variation in mixing is zero) and, as a result, properties of the mixtures ...
This can be illustrated by the equilibrium of carbon monoxide and hydrogen gas, reacting to form methanol. C O + 2 H 2 ⇌ CH 3 OH. Suppose we were to increase the concentration of CO in the system. Using Le Chatelier's principle, we can predict that the concentration of methanol will increase, decreasing the total change in CO.
The deuterated acid is studied in heavy water, since if it were dissolved in ordinary water the deuterium would rapidly exchange with hydrogen in the solvent. [ 19 ] The product species H 3 O + (or D 3 O + ) is a stronger acid than the solute acid, so that it dissociates more easily, and its H–O (or D–O) bond is weaker than the H–A (or D ...
The value of the equilibrium constant for the formation of a 1:1 complex, such as a host-guest species, may be calculated with a dedicated spreadsheet application, Bindfit: [4] In this case step 2 can be performed with a non-iterative procedure and the pre-programmed routine Solver can be used for step 3.
The preceding equilibrium equations are typically applied for each phase (liquid or vapor) individually, but the result can be plotted in a single diagram. In a binary boiling-point diagram, temperature (T ) (or sometimes pressure) is graphed vs. x 1. At any given temperature (or pressure) where both phases are present, vapor with a certain ...
At equilibrium, the rate of transfer of CO 2 from the gas to the liquid phase is equal to the rate from liquid to gas. In this case, the equilibrium concentration of CO 2 in the liquid is given by Henry's law, which states that the solubility of a gas in a liquid is directly proportional to the partial pressure of that gas above the liquid. [1]