Search results
Results from the WOW.Com Content Network
Collects steam at the top of the boiler (well above the water level) so that it can be fed to the engine via the main steam pipe, or dry pipe, and the regulator/throttle valve. [2] [5] [6]: 211–212 [3]: 26 Air pump / Air compressor Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system.
The easiest way to overcome this problem is by superheating the steam. On the T–s diagram above, state 3 is at a border of the two-phase region of steam and water, so after expansion the steam will be very wet. By superheating, state 3 will move to the right (and up) in the diagram and hence produce a drier steam after expansion.
In the simple case, this can be a relatively simple task as in the internal combustion engine in which the valves always open and close at the same points. This is not the ideal arrangement for a steam engine, though, because greatest power is achieved by keeping the inlet valve open throughout the power stroke (thus having full boiler pressure, minus transmission losses, against the piston ...
Indicator diagram for steam locomotive [3] Specifically, the diagram records the pressure of steam versus the volume of steam in a cylinder, throughout a piston's cycle of motion in a steam engine. The diagram enables calculation of the work performed and thus can provide a measure of the power produced by the engine. [4]
An oscillating cylinder engine cannot be reversed by means of the valve linkage (as in a normal fixed cylinder) because there is none. Reversing of the engine can be achieved by reversing the steam connections between inlet and exhaust or, in the case of small engines, by shifting the trunnion pivot point so that the port in the cylinder lines up with a different pair of ports in the port face.
Screw-driven steamships generally carry the ship prefix "SS" before their names, meaning 'Steam Ship' (or 'Screw Steamer' i.e. 'screw-driven steamship', or 'Screw Schooner' during the 1870s and 1880s, when sail was also carried), paddle steamers usually carry the prefix "PS" and steamships powered by steam turbine may be prefixed "TS" (turbine ship).
Diagram showing lap and lead and their relation to valve travel. When on the move, a steam locomotive requires steam to enter the cylinder at precise times relative to the piston's position. [3] This entails controlling the admission and exhaust of steam to and from the cylinders with a valve linked to the motion of the piston. [3]
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.