Search results
Results from the WOW.Com Content Network
Operating point analysis — determines the dc operating point of the circuit with inductors shorted and capacitors opened. Operating point sweep analysis — determines the values of output variables while one or two specified independent voltage or current source is stepped over; Pole-zero analysis (AC) Small-Signal distortion analysis and ...
List of free analog and digital electronic circuit simulators, available for Windows, macOS, Linux, and comparing against UC Berkeley SPICE.The following table is split into two groups based on whether it has a graphical visual interface or not.
It is designed to run on 32-bit or 64-bit editions of Windows 7, 8, 8.1, 10, and macOS 10.9+. [2] Summary of major changes from LTspice IV to LTspice XVII are: Add 64-bit executables. [6] Add Unicode characters in schematics, netlists, plot. [6] Add device equations for IGBT, diode soft recovery, arbitrary state machine. [6]
It performs nonlinear DC and transient analysis, Fourier analysis, and AC analysis linearized at an operating point. [4] It is fully interactive and command driven. It can also be run in batch mode or as a server. The output is produced as it simulates.
Quite Universal Circuit Simulator (Qucs) is a free-software electronics circuit simulator software application released under GPL. It offers the ability to set up a circuit with a graphical user interface and simulate the large-signal, small-signal and noise behaviour of the circuit.
The first Windows version was released in 1993 as TINA 4.0 for analog, digital, and mixed circuits. [3] TINA 9.0 also includes microcontroller (MCU) simulation, RF network analysis, optimization, and printed circuit board design. [2] TINA development was at version 10, released in 2013, and is at major version 11 since 2016. [4]
Simulation software allows for the modeling of circuit operation and is an invaluable analysis tool. Due to its highly accurate modeling capability, many colleges and universities use this type of software for the teaching of electronics technician and electronics engineering programs.
Nodal analysis uses the concept of a node voltage and considers the node voltages to be the unknown variables. [2]: 2-8 - 2-9 For all nodes, except a chosen reference node, the node voltage is defined as the voltage drop from the node to the reference node. Therefore, there are N-1 node voltages for a circuit with N nodes. [2]: 2-10