enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST connectors are electrical connectors manufactured to the design standards originally developed by J.S.T. Mfg. Co. (Japan Solderless Terminal). [1] JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors.

3. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...

4. U.S. Military connector specifications - Wikipedia

   en.wikipedia.org/wiki/U.S._Military_connector...

   A MIL-DTL-38999 circular connector plated with a nickel–teflon composite. Left: plug (male) type connector; Right: receptacle (female) type connector) Electrical or fiber-optic connectors used by U.S. Department of Defense were originally developed in the 1930s for severe aeronautical and tactical service applications, and the Type "AN" series set the standard for modern military circular ...

5. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Bullet terminals, male and female (right-center, with blue wires) A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and ...

6. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   Left to right, modular connectors: 8P8C plug, 6P6C plug, 6P4C plug, 4P4C plug, 6P6C jack. An 8P8C modular plug. This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve).

7. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   Crimp contacts are assembled by inserting a stripped wire end into a cavity in the rear of the contact, then crushing the cavity using a crimp tool, causing the cavity to grip the wire tightly at many points. The crimped contact is then inserted into the connector where it locks into place.