Search results
Results from the WOW.Com Content Network
Compact fluorescent lamp with GU24 cap. A GU24 lamp fitting is a bi-pin connector for compact fluorescent lamps (CFL) or LED lamps that uses a bayonet mount–like twist-lock bi-pin connector instead of the Edison screw fitting used on many CFLs, LED lamps and incandescent light bulbs.
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
AC generator; 51 DC at rectifiers: 51e as 51, with choke coil 59 AC out, rectifier in, light switch 51, 51-, 51a 59a charge, rotor out 59 64 generator control light Generator, voltage regulator; 61 charge indicator (charge control light) B+ battery + 51, 51B+, B+30, B+51 B- battery - 31B- D+ dynamo/alternator diode+ D- dynamo/alternator diode- DF
Lamp harp with fluorescent bulb. A lamp harp is the component of a lamp to which the lamp shade is attached. It typically comes in two separate parts, a saddle which is fastened under the lamp socket, and the harp itself which consist of a lightweight frame attached to the saddle at its lower end and extending upwards to a point above the bulb.
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
A wide variety of special light fixtures are created for use in the automotive lighting industry, aerospace, marine and medicine sectors. [2] [3] Portable light fixtures are often called lamps, as in table lamp or desk lamp. In technical terminology, the lamp is the light source, which, in casual terminology, is called the light bulb.
230/240-volt incandescent light bulb with E27 screw baseEdison screw (ES) is a standard lightbulb socket for electric light bulbs. It was developed by Thomas Edison (1847–1931), patented in 1881, [1] and was licensed in 1909 under General Electric's Mazda trademark.
Other ceramic pieces would typically be used as a junction point between the wiring system proper, and the more flexible cloth-clad wiring found in light fixtures or other permanent, hard-wired devices. When a generic power outlet was desired, the wiring could run directly into the junction box through a tube of protective loom and a ceramic ...