Ads
related to: aux to rca splitter cable installationcrutchfield.com has been visited by 100K+ users in the past month
- TVs
Shop Our Selection of 4K and LED
TVs, Projectors and Accessories
- A/V Receivers
Power for All Your Speakers and
Connections for All Your A/V Gear
- Home Speakers
From Bookshelf Speakers to Floor
Standing Towers, Shop Great Sound
- Sound Bar Speakers
The Simple and Popular Solution to
Get Better Sound from Your TV
- TVs
Search results
Results from the WOW.Com Content Network
Video In Video Out, usually seen as the acronym VIVO (commonly pronounced vee-voh), is a graphics card port which enables some video cards to have bidirectional (input and output) video transfer through a Mini-DIN, usually of the 9-pin variety, and a specialised splitter cable (which can sometimes also transfer sound).
A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends. The Y-cable can resemble the Latin letter "Y".
The RCA connector [3] is a type of electrical connector commonly used to carry audio and video signals. The name RCA derives from the company Radio Corporation of America, which introduced the design in the 1930s. [4] The connector’s male plug and female jack are called RCA plug and RCA jack. It is also called RCA phono connector [5] or phono ...
For similar reasons, "wye"-cables (or "Y-splitters") should not be used to combine two line out signals into a single line in. Each line output would be driving the other line output as well as the intended input, again resulting in a much heavier load than designed for. This will result in signal loss and possibly even damage.
Video in video out (usually seen as the acronym VIVO), commonly pronounced (/ ˈ v i. v oʊ / VEE-voh), is a graphics port which enables some video cards to have bidirectional (input and output) analog video transfer through a mini-DIN connector, usually of the 9-pin variety, and a specialised splitter cable (which can sometimes also transfer analog audio).
The USB Type-C Cable and Connector Specification specifies a mapping from a USB-C jack to a 4-pole TRRS jack, for the use of headsets, and supports both CTIA and OMTP (YD/T 1885–2009) modes. [78] Some devices transparently handle many jack standards, [79] [80] and there are hardware implementations of this available as components. [81]
Three RCA connectors - yellow for composite video, and white and red for stereo audio RCA connector: Widely used in consumer electronics for audio and video. A single connector must be used for each signal. SCART: Consumer electronics, mostly in Europe. Carries analog stereo sound, along with composite video and/or RGB video.
Typical live use of a multicore (thick cable on stage) Multicores usually create a link between the stage and sound desk, or live room and control room.When used in sound reinforcement, the multicore cable runs from the stage box or microphone splitter to the front-of-house sound desk, where it connects to a mixing console. [2]
Ads
related to: aux to rca splitter cable installationcrutchfield.com has been visited by 100K+ users in the past month