Search results
Results from the WOW.Com Content Network
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
Audiogram. An audiogram is a graph that shows the audible threshold for standardized frequencies as measured by an audiometer.The Y axis represents intensity measured in decibels (dB) and the X axis represents frequency measured in hertz (Hz). [1]
In other media, such as underwater, a reference level of 1 μPa is used. [9] These references are defined in ANSI S1.1-2013. [10] The main instrument for measuring sound levels in the environment is the sound level meter. Most sound level meters provide readings in A, C, and Z-weighted decibels and must meet international standards such as IEC ...
The nominal level and the reference voltage against which it is expressed depend on the line level being used. While the nominal levels themselves vary, only two reference voltages are common: decibel volts (dBV) for consumer applications, and decibels unloaded (dBu) for professional applications. The decibel volt reference voltage is 1 V RMS ...
Dynamic range in analog audio is the difference between low-level thermal noise in the electronic circuitry and high-level signal saturation resulting in increased distortion and, if pushed higher, clipping. [23] Multiple noise processes determine the noise floor of a system.
Sound exposure level (SEL) is a logarithmic measure of the sound exposure of a sound relative to a reference value. Sound exposure level, denoted L E and measured in dB , is defined by [ 1 ]
The Sound Reduction Index is expressed in decibels (dB). It is the weighted sound reduction index for a partition or single component only. This is a laboratory-only measurement, which uses knowledge of the relative sizes of the rooms in the test suite, and the reverberation time in the receiving room, and the known level of noise which can pass between the rooms in the suite by other routes ...
dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels.For example, phase noise is expressed in dBc/Hz at a given frequency offset from the carrier. dBc can also be used as a measurement of Spurious-Free Dynamic Range between the desired signal and unwanted spurious outputs resulting from the use of signal converters such as a digital ...