Search results
Results from the WOW.Com Content Network
A component of an HVAC system that adds heat to air or an intermediate fluid by burning fuel (natural gas, oil, propane, butane, or other flammable substances) in a heat exchanger. gas furnace heat exchanger A gas furnace heat exchanger is responsible for the transfer of heat from inside the furnace into the air outside the furnace.
At the furnace, cool air passes into the furnace, usually through an air filter, through the blower, then through the heat exchanger of the furnace, whence it is blown throughout the building. One major advantage of this type of system is that it also enables easy installation of central air conditioning , simply by adding a cooling coil at the ...
ICP is a Carrier subsidiary. ICP makes oil and gas furnaces, heat pumps, and central air-conditioning systems for residential and commercial customers. [1] It manufacturers, markets, and sells residential heating and cooling systems under the Arcoaire, Comfortmaker, Day & Night, Heil, KeepRite, Lincoln, and Tempstar brands; its commercial units, with up to 25 tons of cooling capacity, are sold ...
A heat pump in combination with heat and cold storage. A ground source heat pump (also geothermal heat pump) is a heating/cooling system for buildings that use a type of heat pump to transfer heat to or from the ground, taking advantage of the relative constancy of temperatures of the earth through the seasons.
Heat pumps transfer heat from outside the structure into the air inside. Initially, heat pump HVAC systems were only used in moderate climates, but with improvements in low temperature operation and reduced loads due to more efficient homes, they are increasing in popularity in cooler climates. They can also operate in reverse to cool an interior.
A heat pump in combination with heat and cold storage. A ground source heat pump (also geothermal heat pump) is a heating/cooling system for buildings that use a type of heat pump to transfer heat to or from the ground, taking advantage of the relative constancy of temperatures of the earth through the seasons.
The fluid to be heated passes through the tubes and is thus heated to the desired temperature. The gases from the combustion are known as flue gas. After the flue gas leaves the firebox, most furnace designs include a convection section where more heat is recovered before venting to the atmosphere through the flue gas stack. (HTF=Heat Transfer ...
The operating conditions' optimization of this system is the main challenge, because there are two opposing trends of the performance of the two sub-systems: by way of example, decreasing the evaporation temperature of the working fluid increases the thermal efficiency of the solar panel but decreases the performance of the heat pump, and consequently the COP. [4]