Search results
Results from the WOW.Com Content Network
The Macintosh Hard Disk 20 is the first hard drive developed by Apple Computer specifically for use with the Macintosh 512K.Introduced on September 17, 1985, it was part of Apple's solution toward completing the Macintosh Office (a suite of integrated business hardware & software) announced in January 1985.
The $1,500 model had 2 MB of memory and a 40 MB hard disk. The Classic features several improvements over the Macintosh Plus, which it replaced as Apple's low-end Mac computer: it is up to 25 percent faster than the Plus, [1] about as fast as the SE, [5] and includes an Apple SuperDrive 3.5" floppy disk drive as standard. [19]
The Macintosh can only support one external drive, limiting the number of floppy disks mounted at once to two, but both Apple and third party manufacturers developed external hard drives that connected to the Mac's floppy disk port, which had pass-through ports to accommodate daisy-chaining the external disk drive. Apple's Hard Disk 20 can ...
2 Hard disk drives. 3 Optical drives. 4 Other drives. ... A list of all Apple internal and external drives in chronological order of introduction. Floppy disk drives
Circuit components of the external USB SuperDisk for Macintosh. The drive itself is the same size as a standard 3.5″ floppy drive, but uses an ATA interface. On the right is the USB-to-ATA adapter, which plugs into an intermediate fan-out and power supply daughterboard that is inside the rear of the Mac drive's casing.
On SCSI hard disk drives, the SCSI controller can directly control spin up and spin down of the drives. Some Parallel ATA (PATA) and Serial ATA (SATA) hard disk drives support power-up in standby (PUIS): each drive does not spin up until the controller or system BIOS issues a specific command to do so. This allows the system to be set up to ...
In computer operating systems, memory paging (or swapping on some Unix-like systems) is a memory management scheme by which a computer stores and retrieves data from secondary storage [a] for use in main memory. [1] In this scheme, the operating system retrieves data from secondary storage in same-size blocks called pages.
The data returned gives information about the drive attached to the controller. There are three ATA commands involved in creating and using a host protected area. The commands are: IDENTIFY DEVICE; SET MAX ADDRESS; READ NATIVE MAX ADDRESS; Operating systems use the IDENTIFY DEVICE command to find out the addressable space of a hard drive.