Search results
Results from the WOW.Com Content Network
In electrical engineering, a limit switch is a switch operated by the motion of a machine part or the presence of an object. A limit switch can be used for controlling machinery as part of a control system , as a safety interlock , or as a counter enumerating objects passing a point.
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
For example, a surface ceiling light is shown by one symbol, a recessed ceiling light has a different symbol, and a surface fluorescent light has another symbol. Each type of switch has a different symbol and so do the various outlets. There are symbols that show the location of smoke detectors, the doorbell chime, and thermostat.
A less common symbol is simply a series of peaks on one side of the line representing the conductor, rather than back-and-forth. Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle ...
IEC 60204-1 / EN 60204 Safety of machinery – Electrical equipment of machines – Part 1: General requirements This is a standard published by the International Electrotechnical Commission (IEC), published in parallel by CENELEC ( European Committee for Electrotechnical Standardization ).
The utilization of the binary properties of electrical switches to perform logic functions is the basic concept that underlies all electronic digital computer designs. Shannon's thesis became the foundation of practical digital circuit design when it became widely known among the electrical engineering community during and after World War II .
Means that a feature of size is at the limit of its size tolerance in the direction that leaves the least material on the part. Thus an internal feature of size (e.g., a hole) at its biggest diameter, or an external feature of size (e.g., a flange) at its smallest thickness. The GD&T symbol for LMC is a circled L. (See also MMC and RFS.)
An output signal switching device (OSSD) is an electronic device used as part of the safety system of a machine.It provides a coded signal which, when interrupted due to a safety event, signals the machine to shut down.