Search results
Results from the WOW.Com Content Network
The heating value depends on the source of gas that is used and the process that is used to liquefy the gas. The range of heating value can span ±10 to 15 percent. A typical value of the higher heating value of LNG is approximately 50 MJ/kg or 21,500 BTU/lb. [2] A typical value of the lower heating value of LNG is 45 MJ/kg or 19,350 BTU/lb.
It is the rate of heat transfer needed to freeze 1 short ton (907 kg) of water into ice in 24 hours. In the United States and Canada, the R-value that describes the performance of thermal insulation is typically quoted in square foot degree Fahrenheit hours per British thermal unit (ft 2 ⋅°F⋅h/Btu).
1 to 3 ratio of salt to ice. Dry ice: Tetrachloroethylene-22 Dry ice: Carbon Tetrachloride-23 Dry ice: 1,3-Dichlorobenzene-25 Dry ice: o-Xylene-29 Liquid N 2: Bromobenzene-30 Dry ice: m-Toluidine-32 Dry ice: 3-Heptanone-38 Ice: Calcium chloride hexahydrate -40 1 to 0.8 ratio of salt to ice. Dry ice: Acetonitrile-41 Dry ice: Pyridine-42 Dry ice ...
The standard temperature for metric measurement is 15 degrees Celsius (i.e. 59 degrees Fahrenheit) while for English measurement the standard temperature is 60 °F. Gas undergoes a slight expansion when the temperature is raised from 15 °C (59 °F) to 60 °F and this expansion is built into the above factor for gas.
The density of dry ice increases with decreasing temperature and ranges between about 1.55 and 1.7 g/cm 3 (97 and 106 lb/cu ft) below 195 K (−78 °C; −109 °F). [3] The low temperature and direct sublimation to a gas makes dry ice an effective coolant , since it is colder than water ice and leaves no residue as it changes state. [ 4 ]
The contribution of the muscle to the specific heat of the body is approximately 47%, and the contribution of the fat and skin is approximately 24%. The specific heat of tissues range from ~0.7 kJ · kg−1 · °C−1 for tooth (enamel) to 4.2 kJ · kg−1 · °C−1 for eye (sclera). [13]
The therm (symbol, thm) is a non-SI unit of heat energy equal to 100,000 British thermal units (BTU), [1] and approximately 105 megajoules, 29.3 kilowatt-hours, 25,200 kilocalories and 25.2 thermies. One therm is the energy content of approximately 100 cubic feet (2.83 cubic metres) of natural gas at standard temperature and pressure. However ...
This regulation defines a standard cubic foot, for compressed or liquefied gases in refillable cylinders other than LPG by, "A standard cubic foot of gas is defined as a cubic foot at a temperature of 21 °C (70 °F) and a pressure of 101.325 kilopascals [kPa] (14.696 psia)". [4]