Ads
related to: scr diode tester kit
Search results
Results from the WOW.Com Content Network
A silicon-controlled switch (SCS) behaves nearly the same way as an SCR; but there are a few differences. Unlike an SCR, an SCS switches off when a positive voltage/input current is applied to another anode gate lead. Unlike an SCR, an SCS can be triggered into conduction when a negative voltage/output current is applied to that same lead.
Typically, the voltage is controlled by reverse-parallel-connected silicon-controlled rectifiers , but in some circumstances with three-phase control, the control elements can be a reverse-parallel-connected SCR and diode. [2] [3] Another way to limit motor starting current is a series reactor. If an air core is used for the series reactor then ...
A curve tracer is a specialised piece of electronic test equipment used to analyze the characteristics of discrete electronic components, such as diodes, transistors, thyristors, and vacuum tubes. The device contains voltage and current sources that can be used to stimulate the device under test (DUT).
A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond , but in a practical circuit the inductance of the wires leading to the device imposes a higher limit.
The tester has all these features and can check solid-state devices in and out of circuit. Transistor h fe varies fairly widely with Ic, so measurements with the service type tester give readings that can differ quite a bit from the h fe in the transistor's real life application.
Infrared diode: often changed to "D" for diode J: Jack (least-movable connector of a connector pair), jack connector (connector may have "male" pin contacts and/or "female" socket contacts) all types of connectors, including pin headers. JP: Jumper (link) K: Relay or contactor: L: Inductor or coil or ferrite bead: LD, LED: LED: often changed to ...
The SCR can be calculated for each point on an electrical grid. A point on a grid having a number of machines with an SCR above a number between 1 and 1.5 has less vulnerability to voltage instability. Hence, such a grid is known strong grid or power system. A power system (grid) having a lower SCR has more vulnerability to grid voltage ...
Silicon-controlled rectifier (SCR) This semi-controlled device turns on when a gate pulse is present and the anode is positive compared to the cathode. When a gate pulse is present, the device operates like a standard diode. When the anode is negative compared to the cathode, the device turns off and blocks positive or negative voltages present.
Ads
related to: scr diode tester kit