Ads
related to: iso calibration standard 10012 version
Search results
Results from the WOW.Com Content Network
ISO 10012:2003, Measurement management systems - Requirements for measurement processes and measuring equipment is the International Organization for Standardization (ISO) standard that specifies generic requirements and provides guidance for the management of measurement processes and metrological confirmation of measuring equipment used to support and demonstrate compliance with metrological ...
This is a list of published [Note 1] International Organization for Standardization (ISO) standards and other deliverables. [Note 2] For a complete and up-to-date list of all the ISO standards, see the ISO catalogue. [1] The standards are protected by copyright and most of them must be purchased.
ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories is the main standard used by testing and calibration laboratories. In most countries, ISO/IEC 17025 is the standard for which most labs must hold accreditation in order to be deemed technically competent.
[note 2] For a complete and up-to-date list of all the ISO standards, see the ISO catalogue. [1] The standards are protected by copyright and most of them must be purchased. However, about 300 of the standards produced by ISO and IEC's Joint Technical Committee 1 have been made freely and publicly available. [2]
This is a list of published [Note 1] International Organization for Standardization (ISO) standards and other deliverables. [Note 2] For a complete and up-to-date list of all the ISO standards, see the ISO catalogue. [1] The standards are protected by copyright and most of them must be purchased.
ISO 2859-5:2005 Part 5: System of sequential sampling plans indexed by acceptance quality limit (AQL) for lot-by-lot inspection; ISO 2859-10:2006 Part 10: Introduction to the ISO 2859 series of standards for sampling for inspection by attributes [Withdrawn: replaced with ISO 28590] ISO 2860:1992 Earth-moving machinery — Minimum access dimensions
ISO 12640-5:2013 Part 5: Scene-referred standard colour image data (RIMM/SCID) ISO 12641:1997 Graphic technology – Prepress digital data exchange – Colour targets for input scanner calibration ISO 12641-1:2016 Part 1: Colour targets for input scanner calibration; ISO 12642 Graphic technology - Input data for characterization of four-colour ...
This is a list of published [Note 1] International Organization for Standardization (ISO) standards and other deliverables. [Note 2] For a complete and up-to-date list of all the ISO standards, see the ISO catalogue. [1] The standards are protected by copyright and most of them must be purchased.
Ads
related to: iso calibration standard 10012 version