Search results
Results from the WOW.Com Content Network
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for bidirectional traffic. TCP usually uses port numbers that match the services of the corresponding UDP implementations, if they exist, and vice versa.
ATM Adaptation Layer 5 (AAL5) is an ATM adaptation layer used to send variable-length packets up to 65,535 octets in size across an Asynchronous Transfer Mode (ATM) network. Unlike most network frames, which place control information in the header , AAL5 places control information in an 8-octet trailer at the end of the packet.
Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by the American National Standards Institute and International Telecommunication Union Telecommunication Standardization Sector (ITU-T, formerly CCITT) for digital transmission of multiple types of traffic.
ATM Adaptation Layer 2 (AAL2) is an Asynchronous Transfer Mode (ATM) adaptation layer, used primarily in telecommunications; for example, it is used for the Iu interfaces in the Universal Mobile Telecommunications System, and is also used for transporting digital voice. The standard specifications related to AAL2 are ITU standards I.363.2 and ...
Multiprotocol Encapsulation over ATM is specified in RFC 2684. It defines two mechanisms for identifying the protocol carried in ATM Adaptation Layer 5 (AAL5) frames. It replaces RFC 1483, a standard data link access protocol supported by DSL modems .
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
Introduced in 1985 [1] as a successor to the TABS 9000 series, the 10xx family of ATMs was re-styled to the "i Series" variant in 1991, the "ix Series" variant in 1994, and finally replaced by the Diebold Opteva series of ATMs in 2003. [2] The 10xx series of ATMs were also marketed under the InterBold brand; a joint venture between IBM and
The National Financial Switch was launched by the IDRBT on 27 August 2004, connecting the ATMs of three banks, Corporation Bank, Bank of Baroda and ICICI Bank. [3] [4] [5] The IDRBT then worked towards bringing all major banks in India on board and by December 2009, the network had grown to connect 49,880 ATMs of 37 banks, thereby emerging as the largest network of shared ATMs in the country.