Search results
Results from the WOW.Com Content Network
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
The basic module (M) is a unit of distance equal to one hundred millimetres (100 mm). The myriametre (mym) is a unit of distance equal to ten kilometres (10 km). The hebdometre is a unit of distance equal to ten megametres (10 Mm). The spat (S) is a unit of distance equal to one terametre (1 Tm).
The basic units of the metric system have always represented commonplace quantities or relationships in nature; even with modern refinements of definition and methodology. In cases where laboratory precision may not be required or available, or where approximations are good enough, the commonplace notions may suffice.
The basic idea behind a transit-time measurement of length is to send a signal from one end of the length to be measured to the other, and back again. The time for the round trip is the transit time Δt, and the length ℓ is then 2ℓ = Δt*"v", with v the speed of propagation of the signal, assuming that is the same in both directions.
39 meters – length of a Supersaurus, the longest-known dinosaur and longest vertebrate [128] 52 meters – height of Niagara Falls [33] 55 meters – length of a bootlace worm, the longest-known animal [129] 66 meters – highest possible sea level rise due to a complete melting of all ice on Earth; 83 meters – height of a western hemlock
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
Unlike a linear scale where each unit of distance corresponds to the same increment, on a logarithmic scale each unit of length is a multiple of some base value raised to a power, and corresponds to the multiplication of the previous value in the scale by the base value. In common use, logarithmic scales are in base 10 (unless otherwise specified).
Mannheim's rule had two major modifications that made it easier to use than previous general-purpose slide rules. Such rules had four basic scales, A, B, C, and D, and D was the only single-decade logarithmic scale; C had two decades, like A and B. Most operations were done on the A and B scales; D was only used for finding squares and square ...