enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Valve RF amplifier - Wikipedia

    en.wikipedia.org/wiki/Valve_RF_amplifier

    (The "temperature" of this resistor for noise purposes is more close to the cathode temperature than to room temperature). Thus, the noise figure of tube amplifiers increases with frequency. At 200 MHz, a noise figure of 2.5 (or 4 dB) can be reached with the ECC2000 tube in an optimized "cascode"-circuit with an optimized source impedance.

  3. Valve amplifier - Wikipedia

    en.wikipedia.org/wiki/Valve_amplifier

    6N3C power tube. A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal.Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.

  4. Transimpedance amplifier - Wikipedia

    en.wikipedia.org/wiki/Transimpedance_amplifier

    The sensors which transimpedance amplifiers are used with usually have more capacitance than an op-amp can handle. The sensor can be modeled as a current source and a capacitor C i. [4] This capacitance across the input terminals of the op-amp, which includes the internal capacitance of the op-amp, introduces a low-pass filter in the feedback path.

  5. EL34 - Wikipedia

    en.wikipedia.org/wiki/EL34

    The EL34 is a thermionic vacuum tube of the power pentode type. The EL34 was introduced in 1955 by Mullard, which was owned by Philips. [1] The EL34 has an octal base (indicated by the '3' in the part number) and is found mainly in the final output stages of audio amplification circuits; it was also designed to be suitable as a series regulator by virtue of its high permissible voltage between ...

  6. Single-ended triode - Wikipedia

    en.wikipedia.org/wiki/Single-ended_triode

    A SET tube audio amplifier. A single-ended triode (SET) is a vacuum tube electronic amplifier that uses a single triode to produce an output, in contrast to a push-pull amplifier which uses a pair of devices with antiphase inputs to generate an output with the wanted signals added and the distortion components subtracted.

  7. Damping factor - Wikipedia

    en.wikipedia.org/wiki/Damping_factor

    A high damping factor (which requires low output impedance at the amplifier output) very rapidly damps unwanted cone movements induced by the mechanical resonance of the speaker, acting as the equivalent of a "brake" on the voice coil motion (just as a short circuit across the terminals of a rotary electrical generator will make it very hard to ...

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Power bandwidth - Wikipedia

    en.wikipedia.org/wiki/Power_bandwidth

    The power bandwidth of an amplifier is sometimes taken as the frequency range (or, rarely, the upper frequency limit) for which the rated power output [1] of an amplifier can be maintained (without excessive distortion) to at least half of the full rated power.