Ads
related to: diode substitution chart for wire connectors
Search results
Results from the WOW.Com Content Network
Infrared diode: often changed to "D" for diode J: Jack (least-movable connector of a connector pair), jack connector (connector may have "male" pin contacts and/or "female" socket contacts) all types of connectors, including pin headers. JP: Jumper (link) K: Relay or contactor: L: Inductor or coil or ferrite bead: LD, LED: LED: often changed to ...
See also: Diode logic § Active-high AND logic gate Open-collector buffers connected as wired AND.. The wired AND connection is a form of AND gate.When using open collector or similar outputs (which can be identified by the ⎐ symbol in schematics), wired AND only requires a pull up resistor on the shared output wire.
The codes given in the chart below usually tell the length and width of the components in tenths of millimeters or hundredths of inches. For example, a metric 2520 component is 2.5 mm by 2.0 mm which corresponds roughly to 0.10 inches by 0.08 inches (hence, imperial size is 1008).
dynamo/alternator diode+ D- dynamo/alternator diode- DF dynamo field DF1 dynamo field 1 DF2 dynamo field 2 U, V, W AC three phase terminals Lights 54 brake lights 54g lights 54 55 fog light N 56 spot light 56a headlamp high beam and indicator light 56b low beam F 56d signal flash 57 parking lights 57a parking lights P 57L parking lights left PL 57R
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond , but in a practical circuit the inductance of the wires leading to the device imposes a higher limit.
D-subminiature connectors are often used in industrial products, the DA-15 version being commonly used on rotary and linear encoders. DB-19 connector for an external floppy drive on a Macintosh 512K. The early Macintosh and late Apple II computers used a non-standard 19-pin D-sub for connecting external floppy disk drives.
Ads
related to: diode substitution chart for wire connectors