Search results
Results from the WOW.Com Content Network
Wing ribs of a de Havilland DH.60 Moth. In an aircraft, ribs are forming elements of the airframe structure of a wing, especially in traditional construction.. By analogy with the anatomical definition of "rib", the ribs attach to the main spar, and by being repeated at frequent intervals, form a skeletal shape for the wing.
Good trainer planes and gliders can be made from SPADs. SPAD modelers make equally good advanced planes that can be made with corrugated plastic. They include: RC Airplane Combat, 3D Flying, and are preferred in places where the flyers would normally not risk a more expensive plane and yet want the same flying characteristics of balsa planes.
A typical metal spar in a general aviation aircraft usually consists of a sheet aluminium spar web, with L- or T-shaped spar caps being welded or riveted to the top and bottom of the sheet to prevent buckling under applied loads. Larger aircraft using this method of spar construction may have the spar caps sealed to provide integral fuel tanks.
While internal wing structure commonly provides much of the strength via a combination of spars, ribs and stringers, the external skin typically carries a proportion of the loads too. On many aircraft, the inner volume of the wingbox has also been used to store fuel, which is commonly referred to as being a wet wing design. [1]
The weight of the aircraft is the common factor that links all aspects of aircraft design such as aerodynamics, structure, and propulsion, all together. An aircraft's weight is derived from various factors such as empty weight, payload, useful load, etc. The various weights are used to then calculate the center of mass of the entire aircraft. [37]
A radio-controlled aircraft (often called RC aircraft or RC plane) is a small flying machine that is radio controlled by an operator on the ground using a hand-held radio transmitter. The transmitter continuously communicates with a receiver within the craft that sends signals to servomechanisms (servos) which move the control surfaces based on ...
3D aerobatic flying is a typically performed by model aircraft which have been configured with a higher thrust-to-weight ratio of more than 1:1. In fixed wing aeroplanes large control surfaces assist the aircraft on performing radical maneuvers which allow the aircraft to turn in tighter than conventional turns.
The empennage of an Atlas Air Boeing 747-200. The empennage (/ ˌ ɑː m p ɪ ˈ n ɑː ʒ / or / ˈ ɛ m p ɪ n ɪ dʒ /), also known as the tail or tail assembly, is a structure at the rear of an aircraft that provides stability during flight, in a way similar to the feathers on an arrow.