Ad
related to: mustang 8.8 rear end width chart size dimensions specifications
Search results
Results from the WOW.Com Content Network
The Ford 8.8 is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1983 Ford trucks. The axle was developed to replace the Ford 9-inch axle. This axle is still in production today for a variety of Ford vehicles.
Factory center sections carry two (2) different bearing dimensions (3.0625 and 3.250 in or 77.7875 and 82.5500 mm). Factory axle shaft and differential spline count is 28 and 31, although aftermarket axles with 35 and 40 spline count are readily available from reputable manufacturers. Wide variety of axle bearing flanges were fabricated.
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
The size of the 2010 Mustang GT's dual exhaust tips had been increased by one-half of an inch to 3.5 in (89 mm) while the exhaust note has been improved to enhance the sound of the V8. [54] Like the base V6-equipped Mustang, the 2010 Mustang GT included new spring rates and dampers to improve ride quality and control.
The Mustang has a trunk capacity of 13.5 cubic feet (380 L) with its seats up. [58] The Mustang has the capacity to hold four passengers and uses a rear-wheel drive layout with its engine placed at the front. [59] [60] The vehicle uses a unibody chassis, [61] and is based upon the D2C platform, [62] which it shares with the previous generation ...
The third-generation Mustang was manufactured and marketed by Ford from 1979–1993, using the company's Fox platform and colloquially called the Fox body Mustang.During its third generation, the Mustang evolved through several sub-models, trim levels, and drivetrain combinations during its production and seemed destined for replacement with a front-wheel drive Mazda platform.
From 1980 to 1984, the rear axle was typically a Ford 9-inch axle, with the Ford 8.8 axle being phased in gradually; the 9-inch ended production (alongside this generation) in 1986. The F-250 used an 8 lug version of the Dana 44 TTB called the Dana 44 TTBHD with the Dana 50 TTB being an option.
The 250 cu in (4.1 L) inline-six engine was offered in 1969 in the Mustang, and 1970 in compact Ford cars (Maverick). The 250 was a stroked 200, made by increasing the stroke from 3.126 to 3.91 in (79.4 to 99.3 mm). Output was 155 hp (116 kW) in the Mustang, and the 250 became the base engine in 1971.
Ad
related to: mustang 8.8 rear end width chart size dimensions specifications