enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. How to Clean a Shower Head (And Why You Really Need To) - AOL

   www.aol.com/lifestyle/clean-shower-head-why...

   Once the shower head is reinstalled, turn on the shower for a few minutes to clear out any residual vinegar. You may want to start with a gentle stream and then increase, just in case the shower ...

3. Flocculation - Wikipedia

   en.wikipedia.org/wiki/Flocculation

   The process by which the dosage and choice of flocculant are selected is called a jar test. The equipment used for jar testing consists of one or more beakers, each equipped with a paddle mixer. After the addition of flocculants, rapid mixing takes place, followed by slow mixing and later the sedimentation process.

4. Low-flow fixtures - Wikipedia

   en.wikipedia.org/wiki/Low-flow_fixtures

   Kitchen and bathroom faucets were limited to a flow rate of 2.2 gpm (gallons per minute) at 60 psi, and residential shower heads were limited to a flowrate of 2.5 gpm at 80 psi. [ 3 ] In response to an increasing number of water shortages and increased water utility rates there has been recent legislation by many states leading the way in water ...

5. Clarifying agent - Wikipedia

   en.wikipedia.org/wiki/Clarifying_agent

   Long-chain polymer flocculants, such as modified polyacrylamides, are manufactured and sold by flocculant producers. These can be supplied in dry or liquid form for use in the flocculation process. The most common liquid polyacrylamide is supplied as an emulsion with 10-40% actives and the rest is a non-aqueous carrier fluid, surfactants and ...

6. Ballcock - Wikipedia

   en.wikipedia.org/wiki/Ballcock

   The float is often ball-shaped, hence the name ballcock. The valve is connected to the incoming water supply , and is opened and closed by the lever which has the float mounted on the end. When the water level rises, the float rises with it; once it rises to a pre-set level, the mechanism forces the lever to close the valve and shut off the ...

7. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   Nipple. In plumbing and piping, a nipple is a fitting, consisting of a short piece of pipe, usually provided with a male pipe thread at each end, for connecting two other fittings.

8. Dredge ball joint - Wikipedia

   en.wikipedia.org/wiki/Dredge_ball_joint

   The inner diameter of dredge ball joint pipes ranges from 400 mm to 1200 mm. Dredge ball joint liners can be produced from steel and hard iron materials. To allow for variations of the tilting angle, the ball turning angle of a dredge ball joint is 15 degrees to 18 degrees, and the discharge pipe variation for a dredge ball joint ranges from 10 mm to 30 mm.

9. Ball-and-socket joint - Wikipedia

   en.wikipedia.org/wiki/Ball-and-socket_joint

   The ball-and-socket joint (or spheroid joint) is a type of synovial joint in which the ball-shaped surface of one rounded bone fits into the cup-like depression of another bone. The distal bone is capable of motion around an indefinite number of axes, which have one common center. This enables the joint to move in many directions.