Ads
related to: ring pinion gear chart
Search results
Results from the WOW.Com Content Network
A face gear set typically consists of a disk-shaped gear, grooved on at least one face, in combination with a spur, helical, or conical pinion. A face gear has a planar pitch surface and a planar root surface, both of which are perpendicular to the axis of rotation. [ 1 ]
Its nomenclature, "14-bolt," represents the 14 bolts securing the differential cover, although the ring gear itself is fastened by 12 bolts. Notably, the 14-bolt differential gained traction among Jeep Wrangler owners seeking axle replacement options, [ 2 ] earning the moniker "corporate" 14-bolt because of its association with GM's corporate ...
A spur-gear differential has equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the carrier.
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
Ring gear measures 9.00 in (228.6 mm) Factory nodular center sections are usually marked with an "N". Factory center section's biggest flaw is the pinion bearing pilot support, which are prone to cracking due to the nature of the pinion gear/crown gear relationship.
Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1 ...
Ring Gear: 7.5 inches (191 mm) ... Ring and Pinion gear sets for Jeep Dana 35 rear applications can be used in Ford Ranger IFS (Dana 35) front axles.
Ads
related to: ring pinion gear chart