Search results
Results from the WOW.Com Content Network
That is, it is possible to reach any subscriber with any ADSL speed if one uses multiple loop extenders. A repeater can either be an amplifier or a re-generator. Amplifiers increase the signal level of the analog transmission signal; re-generators demodulate the signal to binary, then re-modulate it into the original transmission frequency.
An older range extender will not be able to repeat the signal of a newer generation router. Security encryption compatibility also matters and must be at the same level of compatibility for the signal to be extended. For example, an older range extender that supports WEP and WPA will not be able to boost a WPA2-encrypted signal from a router.
The RC-5 protocol was developed by Philips in the early 1980s as a semi-proprietary consumer IR remote control communication protocol for consumer electronics.It was subsequently adopted by most European manufacturers, as well as by many US manufacturers of specialty audio and video equipment.
Wi-Fi over Coax is a technology for extending and distributing Wi-Fi signals via coaxial cables.As an in-building wireless solution, Wi-Fi over Coax can make use of existing or new cabling with native impedance of 50 Ω shared by a Wi-Fi access point, cabling run, and antenna.
Similarly, the greater the distance between a radio station and a receiver, the weaker the radio signal, and the poorer the reception. A repeater is an electronic device in a communication channel that increases the power of a signal and retransmits it, allowing it to travel further. Since it amplifies the signal, it requires a source of ...
In electronics, a remote control (also known as a remote or clicker [1]) is an electronic device used to operate another device from a distance, usually wirelessly. In consumer electronics, a remote control can be used to operate devices such as a television set, DVD player or other digital home media appliance. A remote control can allow ...
Consumer IR, consumer infrared, or CIR is a class of devices employing the infrared portion of the electromagnetic spectrum for wireless communications. [citation needed] CIR ports are commonly found in consumer electronics devices such as television remote controls, PDAs, laptops, computers, and video game controllers.
To commit a change in git on the command line, assuming git is installed, the following command is run: [1] git commit -m 'commit message' This is also assuming that the files within the current directory have been staged as such: [2] git add . The above command adds all of the files in the working directory to be staged for the git commit.