enow.com Web Search

  1. Ads

    related to: swivel connectors for oxygen hose

Search results

  1. Results from the WOW.Com Content Network
  2. Scuba set - Wikipedia

    en.wikipedia.org/wiki/Scuba_set

    Swivel fittings between the low pressure hose and the second stage inlet connection are available which allow either a fixed angle or a variable angle between hose and demand valve housing. These allow a wider range of comfortable hose routings, particularly useful for stage and side-mount cylinders, but add another potential point of failure ...

  3. Diving regulator - Wikipedia

    en.wikipedia.org/wiki/Diving_regulator

    A diving regulator or underwater diving regulator is a pressure regulator that controls the pressure of breathing gas for underwater diving.The most commonly recognised application is to reduce pressurized breathing gas to ambient pressure and deliver it to the diver, but there are also other types of gas pressure regulator used for diving applications.

  4. Banjo fitting - Wikipedia

    en.wikipedia.org/wiki/Banjo_fitting

    Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids damage that can be caused by twisting the hose during installation. It also allows the pipe exit direction to be adjusted relative to the fitting, then the bolt tightened ...

  5. Pin Index Safety System - Wikipedia

    en.wikipedia.org/wiki/Pin_Index_Safety_System

    The pin index safety system uses a face seal between the cylinder valve and the associated yoke clamp. There are two holes in specific positions on the cylinder valve body below the outlet port , in positions associated with the gas mixture, which prevent connection of the cylinder to a yoke or pressure regulator with a mis-matched set of pins.

  6. Air-line fitting - Wikipedia

    en.wikipedia.org/wiki/Air-line_fitting

    One side is connected to a flexible supply hose; the other may be attached to a manifold, valve, tool, or another hose. A female coupler is used on the supply side, and a male nipple is used on the receiving side. Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler.

  7. Hose coupling - Wikipedia

    en.wikipedia.org/wiki/Hose_coupling

    A hose coupling is a connector on the end of a hose to connect (or couple) it with another hose or with a tap or a hose appliance, such as an irrigation sprinkler. It is usually made of steel , brass , stainless steel , aluminium or plastic .

  1. Ads

    related to: swivel connectors for oxygen hose