Search results
Results from the WOW.Com Content Network
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
[25] [31] The iPhone can be charged when connected to a computer for syncing across the included USB to dock connector cable, similar to charging an iPod. Alternatively, a USB to AC adapter (or "wall charger", also included) can be connected to the cable to charge directly from an AC outlet. Some models of the iPhone support wireless charging. [32]
The first-generation iPad Pro (12.9-inch models only), and the second-generation iPad Pro, are the only devices in which the Lightning connector supports USB 3.0 host. [9] The only accessory released with USB 3.0 support is the Lightning to USB 3 Camera Adapter. [10] Since iPhone 8 and iPhone X, the Lightning connector is somewhat USB-PD ...
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
No device detected. Both lines are pulled down by 15 kΩ pull-down resistors on the host side. SE0 ≥ 2 μs Connect USB device pulls up either D+ or D− to wake the host from the detached line state. This starts the USB enumeration process. This sets the idle state. D− pull-up D+ pull-up As full speed, then chirp in reset: Idle / J
However, devices built between 2010 and 2020 generally use micro-USB connectors, while newer devices tend to use USB-C. Apple devices often use proprietary connectors. External batteries are most commonly stand-alone devices, which can be cabled to the phone's primary charging connector.
These devices may be computers, servers, or any other networking device. [11] Network adapter usually refers to a piece of computer hardware typically in the form of an Ethernet card, wireless network card, USB network adapter, or wireless game adapter. Hardware network adapters which are either wired or wireless can be installed on a ...
This section describes the power distribution model of USB that existed before Power-Delivery (USB-PD). On devices that do not use PD, USB provides up to 7.5 W through Type-A and Type-B connectors, and up to 15 W through USB-C. All pre-PD USB power is provided at 5 V. For a host providing power to devices, USB has a concept of the unit load ...