enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Comparison of mobile phone standards - Wikipedia

   en.wikipedia.org/wiki/Comparison_of_mobile_phone...

   GSM uses TDMA and FDMA for user and cell separation. UMTS, IS-95 and CDMA-2000 use CDMA. WiMAX and LTE use OFDM. Time-division multiple access (TDMA) provides multiuser access by chopping up the channel into sequential time slices. Each user of the channel takes turns to transmit and receive signals.

3. Time-division multiple access - Wikipedia

   en.wikipedia.org/wiki/Time-division_multiple_access

   Most 2G cellular systems, with the notable exception of IS-95, are based on TDMA. GSM, D-AMPS, PDC, iDEN, and PHS are examples of TDMA cellular systems.. In the GSM system, the synchronization of the mobile phones is achieved by sending timing advance commands from the base station which instruct the mobile phone to transmit earlier and by how much.

4. Circuit Switched Data - Wikipedia

   en.wikipedia.org/wiki/Circuit_Switched_Data

   With the introduction of digital transmission in TDMA-based systems like GSM, CSD provided almost direct access to the underlying digital signal, allowing for higher speeds. At the same time, the speech-oriented audio compression used in GSM actually meant that data rates using a traditional modem connected to the phone would have been even ...

5. Digital AMPS - Wikipedia

   en.wikipedia.org/wiki/Digital_AMPS

   The name TDMA is based on the abbreviation for time-division multiple access, a common multiple access technique which is used in most 2G standards, including GSM, as well as in IS-54 and IS-136. D-AMPS competed against GSM and systems based on code-division multiple access (CDMA).

6. List of wireless network protocols - Wikipedia

   en.wikipedia.org/wiki/List_of_wireless_network...

   Typical 2G standards include GSM and IS-95 with extensions via GPRS, EDGE and 1xRTT, providing Internet access to users of originally voice centric 2G networks. Both EDGE and 1xRTT are 3G standards, as defined by the ITU , but are usually marketed as 2.9G due to their comparatively low speeds and high delays when compared to true 3G technologies.

7. List of wireless network technologies - Wikipedia

   en.wikipedia.org/wiki/List_of_wireless_network...

   The North American Standards IS-54 and IS-136 were also second-generation (2G) mobile phone systems, known as (Digital AMPS) and used TDMA with three time slots in each 30 kHz channel, supporting 3 digitally compressed calls in the same spectrum as a single analog call in the previous AMPS standard. This was later changed to 6 half rate time ...