Search results
Results from the WOW.Com Content Network
Turndown ratio refers to the width of the operational range of a device, and is defined as the ratio of the maximum capacity to minimum capacity. For example, a device with a maximum output of 10 units and a minimum output of 2 units has a turndown ratio of 5.
Compressor characteristic is a mathematical curve that shows the behaviour of a fluid going through a dynamic compressor.It shows changes in fluid pressure, temperature, entropy, flow rate etc.) with the compressor operating at different speeds.
In air conditioning, an inverter compressor is a compressor that is operated with an inverter.. In the hermetic type, it can either be a scroll or reciprocating compressor. ...
The turndown ratio of an ultrasonic meter is probably the largest of any natural gas meter type, and the accuracy and range ability of a high-quality ultrasonic meter is actually greater than that of the turbine meters against which they are proven.
High turn-down ratio: the feed rate to a single ISASMELT installation can easily be scaled up or down, depending on the availability of concentrate and the needs of the smelter Low feed carry over: ISASMELT furnaces typically lose about 1% of the feed as carry-over with the waste gas, meaning that there is less material that needs to be ...
Optionally it has still another frame, with ten more switches and another 200 lines, and so forth, up to a maximum line concentration ratio of 5.9:1 since they all shared the same hundred line links. The line circuit is much like that in 1XB with a line relay for alerting the exchange to a trip condition, and the vertical off-normal contacts of ...
Use cashew cream at a one-to-one ratio for stovetop curries and pasta sauces. This article was originally published on TODAY.com. Show comments. Advertisement. Advertisement. Holiday Shopping Guides.
Principal view of the pumping action of a twin-screw pump with a six-lobe female screw and a five-lobe male screw. A compressor (as opposed to a pump) would be shaped the same way, except that the shape of the lobes would change along the length of the screw, so that the volume of the trapped pockets would get squeezed smaller as they get closer to the exhaust port.