enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Submersible pump - Wikipedia

   en.wikipedia.org/wiki/Submersible_pump

   A submersible pump cable's area of installation is physically restrictive. Cable manufacturers must keep these factors in mind to achieve the highest possible degree of reliability. The size and shape of submersible pump cable can vary depending on the usage and preference and pumping instrument of the installer.

3. Total dynamic head - Wikipedia

   en.wikipedia.org/wiki/Total_dynamic_head

   In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid.TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.

4. Pressure tank - Wikipedia

   en.wikipedia.org/wiki/Pressure_tank

   A simple control system for a water well. Referring to the figure on the left, a submersible water pump is installed in a well.The pressure switch turns the water pump on when it senses a pressure that is less than P lo and turns it off when it senses a pressure greater than P hi.

5. Pumplinx - Wikipedia

   en.wikipedia.org/wiki/Pumplinx

   PumpLinx is a 3-D computational fluid dynamics (CFD) software developed for the analysis of fluid pumps, motors, compressors, valves, propellers, hydraulic systems, and other fluid devices with rotating or sliding components.

6. Grundfos - Wikipedia

   en.wikipedia.org/wiki/Grundfos

   Grundfos (Danish pronunciation: [ˈkʁɔnˀfʌs]) is the largest pump manufacturer in the world, based in Denmark, with more than 19,000 employees globally.. The annual production of more than 16 million pump units, circulator pumps (UP), submersible pumps (SP), and centrifugal pumps (CR).

7. Centrifugal pump - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump

   This pump type operates without a foot valve and without an evacuation device on the suction side. The pump has to be primed with the fluid to be handled prior to commissioning. Two-phase mixture is pumped until the suction line has been evacuated and the fluid level has been pushed into the front suction intake chamber by atmospheric pressure.