enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  3. Structural steel - Wikipedia

    en.wikipedia.org/wiki/Structural_steel

    Requirements for S275JOH pipe tolerances, dimensions and sectional s275 pipe properties are contained in EN 10219-2. 2. S275JOH Steel Pipes manufacture Process The steel manufacturing process shall be at the discretion of the steel producer. S275JOH carbon steel pipes can be made in ERW, SAW or seamless process.

  4. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [ 15 ] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size.

  5. Ship measurements - Wikipedia

    en.wikipedia.org/wiki/Ship_measurements

    Grain Cube (or Grain Capacity) – The maximum space available for cargo measured in cubic metres or feet, the measurement being taken to the inside of the shell plating of the ship or to the outside of the frames and to the top of the beam or underside of the deck plating. It is a measurement of capacity for cargoes such as grain, where the ...

  6. Organ flue pipe scaling - Wikipedia

    en.wikipedia.org/wiki/Organ_flue_pipe_scaling

    Relationship between number of feet, octave and size of an open flue pipe (1′ = 1 foot = about 32 cm) Play ⓘ Scaling is the ratio of an organ pipe's diameter to its length. The scaling of a pipe is a major influence on its timbre. Reed pipes are scaled according to different formulas than for flue pipes.

  7. Display size - Wikipedia

    en.wikipedia.org/wiki/Display_size

    Common screen dimensions are listed in the table below (the most common diagonal dimensions in inches as of 2020 are bolded). If the display is not listed, then the following equations can be used. Note that D is the diagonal (in centimeters or inches), W is the width (in pixels), and H is the height (in pixels).

  8. Tragic discovery in Oregon: Missing hiker’s body found ...

    www.aol.com/news/tragic-discovery-oregon-missing...

    The search for missing hiker Susan Lane-Fournier, 61, took a tragic turn after her body was found over the weekend in Welches, Oregon, an unincorporated community at the base of Mount Hood.

  9. Hollow structural section - Wikipedia

    en.wikipedia.org/wiki/Hollow_structural_section

    Circular HSS are sometimes mistakenly called steel pipe, although true steel pipe is actually dimensioned and classed differently from HSS. (HSS dimensions are based on exterior dimensions of the profile; pipes are also manufactured to an exterior tolerance, albeit to a different standard.)