Search results
Results from the WOW.Com Content Network
A reference range is usually defined as the set of values 95 percent of the normal population falls within (that is, 95% prediction interval). [2] It is determined by collecting data from vast numbers of laboratory tests. [citation needed]
The standard definition of a reference range for a particular measurement is defined as the interval between which 95% of values of a reference population fall into, in such a way that 2.5% of the time a value will be less than the lower limit of this interval, and 2.5% of the time it will be larger than the upper limit of this interval, whatever the distribution of these values.
Normal values of hemoglobin in the 1st and 3rd trimesters of pregnant women must be at least 11 g/dL and at least 10.5 g/dL during the 2nd trimester. [95] Dehydration or hyperhydration can greatly influence measured hemoglobin levels. Albumin can indicate hydration status. If the concentration is below normal, this is called anemia.
Metabolic acidosis is a serious electrolyte disorder characterized by an imbalance in the body's acid-base balance.Metabolic acidosis has three main root causes: increased acid production, loss of bicarbonate, and a reduced ability of the kidneys to excrete excess acids. [5]
"Your blood pressure is supposed to be under 140 over 90, optimally closer to 120 over 80."
The calculated value of the anion gap should always be adjusted for variations in the serum albumin concentration. [15] For example, in cases of hypoalbuminemia the calculated value of the anion gap should be increased by 2.3 to 2.5 mEq/L per each 1 g/dL decrease in serum albumin concentration (refer to Sample calculations, below).
The hematocrit (/ h ɪ ˈ m æ t ə k r ɪ t /) (Ht or HCT), also known by several other names, is the volume percentage (vol%) of red blood cells (RBCs) in blood, [1] [2] measured as part of a blood test. [3] The measurement depends on the number and size of red blood cells. [3] It is normally 40.7–50.3% for males and 36.1–44.3% for ...
Recall that the relationship represented in a Davenport diagram is a relationship between three variables: P CO 2, bicarbonate concentration and pH.Thus, Fig. 7 can be thought of as a topographical map—that is, a two-dimensional representation of a three-dimensional surface—where each isopleth indicates a different partial pressure or “altitude.”