Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The result is an engine that fails to maintain idle RPM and frequently stalls. A jammed actuator may be freed simply by cleaning it. However an actuator that has stopped working due to a fault in its servomotor will need replacement. Air leaks in either the stepper housing or pipes will cause elevated idle RPM.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle.
An actuator is a component of a machine that produces force, torque, or displacement, when an electrical, pneumatic or hydraulic input is supplied to it in a system (called an actuating system). The effect is usually produced in a controlled way. [1] An actuator translates such an input signal into the required form of mechanical energy.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
Bent connecting rod after hydrolock Same connecting rod, turned 90°. Hydrolock (a shorthand notation for hydrostatic lock or hydraulic lock) is an abnormal condition of any device which is designed to compress a gas by mechanically restraining it caused by a liquid entering the device.
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
Mechanical actuators are also frequently used in the field of lasers and optics to manipulate the position of linear stages, rotary stages, mirror mounts, goniometers and other positioning instruments. For accurate and repeatable positioning, index marks may be used on control knobs. Some actuators include an encoder and digital position readout.