Search results
Results from the WOW.Com Content Network
A memory bank is a part of cache memory that is addressed consecutively in the total set of memory banks, i.e., when data item a(n) is stored in bank b, data item a(n + 1) is stored in bank b + 1. Cache memory is divided in banks to evade the effects of the bank cycle time (see above) [=> missing "bank cycle" definition, above]. When data is ...
The name "DIMM" was chosen as an acronym for Dual In-line Memory Module symbolizing the split in the contacts of a SIMM into two independent rows. [6] Many enhancements have occurred to the modules in the intervening years, but the word "DIMM" has remained as one of the generic terms for a computer memory module.
Also some memory controllers have a maximum supported number of ranks. DRAM load on the command/address (CA) bus can be reduced by using registered memory. [citation needed] Predating the term rank (sometimes also called row) is the use of single-sided and double-sided modules, especially with SIMMs. While most often the number of sides used to ...
Registers are normally measured by the number of bits they can hold, for example, an 8-bit register, 32-bit register, 64-bit register, 128-bit register, or more.In some instruction sets, the registers can operate in various modes, breaking down their storage memory into smaller parts (32-bit into four 8-bit ones, for instance) to which multiple data (vector, or one-dimensional array of data ...
(memory density) This is the total memory capacity of the chip. Example: 128 Mib. (memory depth) × (memory width) Memory depth is the memory density divided by memory width. Example: for a memory chip with 128 Mib capacity and 8-bit wide data bus, it can be specified as: 16 Meg × 8. Sometimes the "Mi" is dropped, as in 16×8.
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
Single-level storage (SLS) or single-level memory is a computer storage term which has had two meanings. The two meanings are related in that in both, pages of memory may be in primary storage ( RAM ) or in secondary storage (disk), and that the physical location of a page is unimportant to a process.
Blocking is almost universally employed when storing data to 9-track magnetic tape, NAND flash memory, and rotating media such as floppy disks, hard disks, and optical discs. Most file systems are based on a block device , which is a level of abstraction for the hardware responsible for storing and retrieving specified blocks of data, though ...