Search results
Results from the WOW.Com Content Network
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
The M3 is an American .45-caliber submachine gun adopted by the U.S. Army on 12 December 1942, as the United States Submachine Gun, Cal. .45, M3. [12] The M3 was chambered for the same .45 ACP round fired by the Thompson submachine gun , but was cheaper to mass produce and lighter, at the expense of accuracy. [ 12 ]
A grease gun (pneumatic) A grease gun is a common workshop and garage tool used for lubrication. The purpose of the grease gun is to apply lubricant through an aperture to a specific point, usually from a grease cartridge to a grease fitting or 'nipple'. The channels behind the grease nipple lead to where the lubrication is needed.
The most common causes are accidents with grease guns, paint sprayers, and pressure washers, but working on diesel and gasoline engine fuel injection systems as well as pinhole leaks in pressurized hydraulic lines can also cause this injury. Additionally, there is at least one known case of deliberate self-injection with a grease gun. [2]
An air-pressurized-water fire extinguisher is similar but its water is expelled by the air pressure, it is held by one person, and a flexible hose makes aiming the water stream easy. Handtub A historical fire engine pumped by hand with the water supply held in a tub or cistern on the wagon, the water supply delivered by a bucket brigade .
Attack hose is a fabric-covered, flexible hose used to bring water from the fire pumper to the nozzle. This hose ranges in nominal inside diameter from 1.5 to 3 in (38 to 76 mm) and is designed to operate at pressures up to about 400 psi (2,760 kPa). The standard length is 50 ft (15.24 m). [12] Supply and relay hoses
A water gun using this system is pressurized by air being pumped and compressed into its reservoir. When the trigger is pulled, a valve is opened and the compressed air pushes the water out of the nozzle. [13] Super Soaker started with two pressurized reservoir water guns, and has continued to produce them in various shapes and sizes.
Its capacity is normally around 1,000 kg or 2,200 lb, but the larger units can store even more. A FIBC designed to transport one metric ton (0.98 long tons; 1.1 short tons) of material will itself only weigh 5–7 lb (2.3–3.2 kg). Transporting and loading is done on either pallets or by lifting it from the loops. Bags are made with either one ...