Search results
Results from the WOW.Com Content Network
On-road Cars: 4-tec 2.0, 4-tec 3.0, XO-1, Drag Slash, Ford Fiesta ST, Toyota GR Supra GT4 (Drag Slash is 2WD the rest are all 4WD) Flight: Alias (Drone) Boats: Spartan, Disruptor, M41, Blast (Blast is a nimh 20t motor vs the spartain and M41 having 6s brushless, Spartain has two versions: the Race boat, and the SR, Disruptor is 4s.)
The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
Toyota Motor Corporation's S family is a family of cable operated manual transmissions built for small to mid sized front wheel drive vehicles, but also used in mid-engine applications. The S family has received various upgrades and enhancements over its design life.
The designation of wide versus close ratio affected the lowest gear ratio; [7] for example, the four-speed Muncie transmissions offered in General Motors performance vehicles included the M20 "wide ratio" transmission, which had a first gear ratio of 2.52 or 2.56:1, while the M21 and M22 "close ratio" transmissions had a first gear ratio of 2.20:1.
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...
A later design of cross-drive transmission, the Allison X1100, was used in the 1970s experimental US MBT-70 and XM1 [3] tanks, then later adopted in the M1 Abrams.This adopts a different principle for the steering cross-coupling: instead of a hydro-dynamic torque converter, it uses a hydrostatic combination of a hydraulic pump and a hydraulic motor.
In 1891, the French Panhard et Levassor automobile used a three-speed manual transmission and is considered to have set the template for multi-speed manual transmissions in motor vehicles. [ 3 ] [ 4 ] This transmission used a sliding-gear design without any form of speed synchronization, causing frequent grinding of the gear teeth during gear ...
A 2WD 5 speed transmission found in most light duty Toyota Dyna trucks, this transmission has a drum brake on the rear and steel housings. These transmissions can be used to give a significantly lower first, and a slightly higher overdrive (5th: 0.695:1) when fitted to an R151 4WD gearbox. [4] First Gear: 5.147:1; Second Gear: 2.74:1; Third ...