enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. EIA RF Connectors - Wikipedia

   en.wikipedia.org/wiki/EIA_RF_Connectors

   The flange design, inner and outer conductor dimensions are standardized, by EIA, in the RS-225, 50 Ω (ohm), and RS-259, 75 Ω, standards.They are commonly referred to by the inner diameter of the outer conductor in fractional inches.

3. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   FAKRA connector is a modified SMB connector with a keyed and colour coded plastic housing and latch, used in the automotive industry [5] SMC connector; SSMA connector is a 50 Ohm nominal impedance RF connector which utilizes a 10–36 threaded coupling and is essentially a scaled down version of the SMA. They are characterized by compactness ...

4. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   Where BNC is used, available as 3 connectors with Sync on Green, or 5 connector Red / Green / Blue / Horizontal Sync / Vertical sync. Mac-II/Quadra DA15F: 1152 × 870 @ 75 [8] Macintosh: Mac-DA15F and Sun-13W3 were similar in capability to VGA. Some Sun machines used 4 or 5 BNC connectors to transfer video signal. 1990: 13W3 DB13W3: 1152 × 900 ...

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   flange adapters which attach to a polyethylene pipe with butt fusion to stiffen a junction and allow another flanged pipe or fitting to be bolted on [9]: 341 a fitting that connects pipes of different diameters, genders, or threads ( see § Coupling below ) [ 10 ]

6. UHF connector - Wikipedia

   en.wikipedia.org/wiki/UHF_connector

   The UHF connector [4] is a name for a threaded RF connector. [5] [6] The connector design was invented in the 1930s for use in the radio industry. [7] [4] It is a widely used standard connector for HF transmission lines on full-sized radio equipment, with BNC connectors predominating for smaller, hand-held equipment. [7]

7. Waveguide flange - Wikipedia

   en.wikipedia.org/wiki/Waveguide_flange

   The gap between the flange faces has been exaggerated by a factor of four to make it clearly visible. The choke flange can also be mated with a plain cover flange and still form a pressure seal. A choke connection is formed by mating one choke flange and one cover (or gasket/cover) flange. The central region of the choke flange face is very ...