Search results
Results from the WOW.Com Content Network
Linux also features iwspy, to read the signal, noise and quality of a wireless connection. Other related tools for configuring Ethernet adapters are: ethtool, mii-tool, and mii-diag in Linux and the command dladm show-link in Solaris. The ip suite has a similar purpose and is meant to replace the deprecated ifconfig. [6]
The configuration software of choice is then used to configure the persistent configuration which is applied on boot. It is also possible to configure Linux networking ad-hoc using the ip command from the iproute2 package. The following command can be used to configure the route using ip: [10]
To enable the forwarding of User Datagram Protocol (UDP) broadcasts, including BOOTP, received on an interface, use the ip helper-address command in interface configuration mode. To disable the forwarding of broadcast packets to specific addresses, use the no form of this command. Syntax Description: ip helper-address [vrf name | global ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
The client's IP address, subnet mask, and default gateway address. The IP address and host name of the BOOTP server. The IP address of the server that has the boot image, which the client needs to load its operating system. When the client receives this information from the BOOTP server, it configures and initializes its TCP/IP protocol stack ...
ipconfig in Mac OS X serves as a wrapper to the IPConfiguration agent, and can be used to control the Bootstrap Protocol and DHCP client from the command-line interface. [8] For example, you can release and renew an IP address if it happened to be assigned incorrectly by the DHCP server during the automated assignment process. [9]
The DHCP server permanently assigns an IP address to a requesting client from a range defined by an administrator. This is like dynamic allocation, but the DHCP server keeps a table of past IP address assignments, so that it can preferentially assign to a client the same IP address that the client previously had. Manual allocation
Where no DHCP server is available to assign a host an IP address, the host can select its own link-local address. Using a link-local address, hosts can communicate over this link but only locally; Access to other networks and the Internet is not possible. There are some link-local IPv4 address implementations available: