enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rod end bearing - Wikipedia

   en.wikipedia.org/wiki/Rod_end_bearing

   A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links, tie rods, or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...

3. Ball joint - Wikipedia

   en.wikipedia.org/wiki/Ball_joint

   A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...

4. Steering linkage - Wikipedia

   en.wikipedia.org/wiki/Steering_linkage

   The steering linkage which connects the steering gearbox to the front wheels consists of a number of rods. These rods are connected with a socket arrangement similar to a ball joint, called a tie rod end, allowing the linkage to move back and forth freely so that the steering effort will not interfere with the vehicles up-and-down motion as the ...

5. Parallelogram steering linkage - Wikipedia

   en.wikipedia.org/wiki/Parallelogram_steering_linkage

   A parallelogram steering linkage is called such because like its namesake, the two sides of the linkage run parallel to each other and are equal in distance. This type of steering linkage uses four tie rods, one inner and one outer on each side (left and right) that are connected by an adjustment sleeve, a center link (which runs between the tie rods), an idler arm on the passenger side, and a ...

6. Recirculating ball - Wikipedia

   en.wikipedia.org/wiki/Recirculating_ball

   Recirculating ball, also known as recirculating ball and nut or worm and sector, is a steering mechanism commonly found in older automobiles, off-road vehicles, and some trucks. Most newer cars use the more economical rack and pinion steering instead, but some upmarket manufacturers (such as BMW and Mercedes-Benz ) held on to the design until ...

7. Pitman arm - Wikipedia

   en.wikipedia.org/wiki/Pitman_arm

   In automotive or truck steering systems, the Pitman arm acts as a linkage attached to the steering box (see recirculating ball) sector shaft, [1] it converts the angular motion of the sector shaft into the linear motion needed to steer the wheels. The arm is supported by the sector shaft and supports the drag link or center link with a ball ...